RAID eSATA-150 Multilane 4x External 4Ports Low Profile PCI Host

Discontinued ! 



Multilane 4x eSATA 4Ports RAID !

Add LyCOM Reliable and Eye-Pattern Proven 1,500Mbps of Serial ATA External 4 Ports and RAID 0, RAID 1, RAID 0+1, RAID 1+S(Mirrored-Sparing) to your system


  • Type 4x Multilane SATA connector with thumbscrews

  • 48 bits LBA can Break Capacity-Limit to Support HDD larger than 137GB
  • Four high speed Serial ATA interface ports, each supporting 1st generation Serial ATA data rates 1.5Gb/s
  • Hot-plug capability
  • Fully compliant with Serial ATA 1.5G specifications
  • Provides RAID 0 (Stripping) to greatly increase the performance of data transfer by simultaneously writing data to multiple drives
  • Provides RAID 1 (Mirroring) to protect the data from a disk failure by writing identical data on two drives
  • RAID 0+1 (Mirrored-Stripping) combine both Striping and Mirroring technologies to provide both the performance enhancements that come from Striping and the data availability and integrity that comes from Mirroring
  • RAID 1+S (Mirrored-sparing) can automatically replace the failed drive and rebuild the system when booting HDD is failed
  • Supports ATAPI commands
  • Supports Spread Spectrum in receiver
  • Independent 256-byte FIFOs (32 bit * 64 deep) per Serial ATA channel for host reads and writes
  • Compliant with PCI Specification, revision 2.2
  • Low Profile PCI form factor
  • Integrated PCI DMA engines
  • Four Pin header on board for LED connection
  • 32 bit, 33/66MHz fully compliant PCI host interface
  • Supports Windows 98, Millennium, NT 4.0, 2000, XP, 2003 and Linux, Novell Netware
  • Acts as NON-RAID when BIOS not configured RAID
  • Supports 64bit / 32bit Windows Vista
  • Linux 32bit / 64bit drivers support for Fedora Core2, Fedora Core3, Fedora Core4, RHEL 4.0, RHEL 4.0 Up1, SuSE 9.0 SP1 RC5, SuSE Pro 9.2, SuSE Pro 9.3. See SiliconImage SiI3114.
  • Fully RoHS compliant
  • Chipset : SiI3114